I have only checked that MSTS AE displays the map and not tried any modifications to the activities. Microsoft Train Simulator 2 is an unfinished continuation of the railway simulator issued in 2001. I do not know if they have any detrimental effect on running the route in Open Rails so will not be held responsible for any malfunction. The above modifications allow MSTS AE to display the map. It goes without saying that, before editing any files, they should be backed up, just in case! Train simulation game Hmmsim has become new and diverseIn Hmmsim 2, advanced graphics, new map, outer view of train, dynamic trains and scoring mode has been. Open the sigscr.dat file and scroll down to line 1782 (SCRIPT CCOR_CL-USS_H1A_GR) and insert a line : extern float enabled after the other 'extern float' lines, then save the file, In both cases, there are two SignalDrawStates with the first being shown as 0 so it's logical (at least to MSTS) that the second should be 1 and not 2.ĪE also reports a problem with CCOR_CL-USS_H1A_GR. While you're editing the file, make the same change to line 2224 (within SignalType ( "CCOR_CL-USS_H3A_LR"). That line is within SignalType ( "CCOR_CL-USS_H2A_LR" and is currently : SignalDrawState ( 2 which I changed to : SignalDrawState ( 1 Starting AE and opening either of the supplied activities causes an error to be reported on line 2189 of the sigscr.dat file. I copied the MILW-Idaho v2 folders into a default MSTS installation, allowing all overwrites. If you still want to use MSTS AE, I've found 2 'errors' which cause AE to fail and one which gives an error message but doesn't stop AE.
I was doing my upgrade to the map set for the original Gap to reflect any alterations and additions to the trackwork when I found out that I could not just click on my shortcut to the MSTS AE because that option was no longer available.